|

True Test Downhole Corrosion Monitoring Tool
Catch your corrosion problem BEFORE failure or damage occurs!
The Eagle True Test Monitoring Tool will improve corrosion monitoring. Previously, corrosion monitoring was routinely accomplished by placing weight loss coupons in the system, on or near the well head. The information compiled from this location is not representative of subsurface corrosion conditions effecting downhole tubular and pumps. Now, with the Eagle True Test, corrosion rates downhole can be established during routine pulling of your well, thus enhancing the results of your corrosion treatment programs.
Use of the Eagle True Test will help improve your corrosion monitoring and increase profits.
- Identify severity of corrosion on problem wells
- Reduce frequent pulling cost caused by corrosion
- Identify current corrosion versus previous corrosion
- Maximize chemical effectiveness
- Identify corrosion versus abrasion
- Optimize downhole equipment replacement cost
- In addition to these advantages, Eagle True Test Monitoring Tools deliver exact downhole corrosion information needed to substantially increase service life.
Application
Standard models are recommended to be used in rod string. (Mid string and just above pump). Caution should be used not to exceed load limits. For applications exceeding these limits, consult your eagle representative.
Optimize your downhole equipment cost by identifying your corrosion treating needs with the Eagle True Test Downhole Corrosion Monitoring Tool.

| Chemical Analysis |
| Construction |
Standard 4130 Alloy |
Optional 316 Stainless Steel |
| Carbon |
.28/.33 |
.08 |
| Manganese |
.40/.60 |
2.00 |
| Phosphorus |
.025 |
.040 |
| Sulphur |
.025 |
.030 |
| Silicon |
.15/.35 |
1.00 |
| Chromium |
.80/1.10 |
16.00/18.00 |
| Nickel |
.25 |
- |
| Molybdenum |
.15/.25 |
- |
|
Chemical Analysis |
Recommended Make-up Form Hand Tight Position |
|
Size |
Model no |
Coupling
Box O.D. |
Dims |
Max Rod Load |
New |
Rerun |
|
male to male |
male to female |
-A- |
-B- |
Alloy |
Stainless |
Min |
Max |
Min |
Max |
|
5/8 |
MM
.625 |
MM
.625 |
1
1/2 |
10.00 |
1.500 |
21,780 |
10,890 |
21/64 |
25/64 |
20/64 |
22/64 |
|
3/4 |
MM
.750 |
MM
.750 |
1
5/8 |
10.25 |
1.625 |
29,250 |
14,625 |
25/64 |
30/64 |
23/64 |
25/64 |
|
7/8 |
MM
.875 |
MM
.875 |
1
5/8 |
10.50 |
1.625 |
37,845 |
18,922 |
29/64 |
33/64 |
28/64 |
31/64 |
|
1.0 |
MM
1.000 |
MM
1.000 |
2.00 |
11.38 |
2.000 |
52,785 |
26,392 |
37/64 |
43/64 |
36/64 |
40/64 |
Request
Literature |